Using The Appliance - TEFAL ZE350B65 Manual De Instrucciones

CAUTION: the safety precautions are part of
the appliance. Read them carefully before
using your new appliance for the first time.
Keep them in a place where you can find
and refer to them later on.
DESCRIPTION
A Pusher
B
Feed tube
C Cover
D Sieve
E
Juice collector
F
Pouring spout
SAFETY SYSTEM
To start the juicer, the cover (C)
must be fitted correctly (Fig. 2).
At the end of a cycle, turn the
BEFORE FIRST USE
We recommend that you wash
the removable parts (A, B, C, D,
E, F, G, H) before the first use (see
section "Cleaning and care").
• Unpack the appliance and

USING THE APPLIANCE

• Place the juice collector (E)
on the body of the appliance
(see Fig. 1).
• Place the sieve (D) in the juice
collector (E). Ensure that the
sieve is properly clipped onto the
drive shaft (K) (see Fig. 1).
• Fit the cover
appliance in order to have the
(C)
on the
G Non-drip spout
H Pulp collector
I
Safety clamps
J
Control button
K
Drive shaft
L
Motor unit
control button to "0" and wait
until the sieve (D) stops completely
before removing the cover (C).
then place it on a solid, stable
worktop, remove the cover (C)
and take out the protective card
on the sieve (D).
pulp evacuation exit to the rear
(see fig.2).
• Fit the pulp collector (H) on
the rear of the appliance
(see Fig. 3).
• Lock the two clamps (I) on the
cover (C). You will hear an
audible "click" (see Fig. 4).
• Slide the pusher (A) into the feed
1