Optional Accessories; Protecting The Environment - BTI BH 3-30 BOX Manual Del Usuario

WARNING: Always wait until the motor has come to
a complete standstill before changing the direction
of rotation.
1. Choose and install the appropriate chuck, adapter, and/or
bit onto to the tool. Refer to Bit and Bit Holders.
2. Using the mode selector dial
appropriate to desired application. Refer to
Operation Modes.
3. Adjust the side handle
4. Place the bit/chisel on the desired location.
5. Select the direction of rotation using the forward/reverse
slider 2 . When changing the position of the control slider,
be sure the trigger is released.
a. Push the forward/reverse slider
forward (RH) rotation. See arrows on tool.
b. Push the forward/reverse slider
reverse (LH) rotation.
WARNING: Always wait until the motor has come to
a complete standstill before changing the direction
of rotation.
6. Depress the trigger switch
the trigger switch, the faster the tool will operate. For
maximum tool life, use variable speed only for starting holes
or fasteners.
WARNING:
• Do not use this tool to mix or pump easily combustible
or explosive fluids (benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
MAINTENANCE
Your BTI power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Lubrication
Various types of SDS-Plus drill bits and chisels are available as
an option. Accessories and attachments used must be regularly
lubricated around the SDS-Plus fitment.
Consult your dealer for further information on the
appropriate accessories.
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
3 , select the mode
5 as required.
2 to the LH-side for
to the RH-side for
2
1 . The farther you depress
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.

Optional Accessories

WARNING: Since accessories, other than those offered by
BTI, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce
the risk of injury, only BTI recommended accessories
should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at www.BTI.de.
ENGLISH
23