Adjusting The Position Of The Projected Image - Epson ELPMB30 Manual Del Usuario

Adjusting the Position of the Projected Image

If the projected image is not fit to the screen, adjust the projection position as follows.
v Adjustment by the Lens Shift (for projectors with the lens shift function only)
Adjust the projection position by the lens shift function of the projector. For the details on the lens shift, refer to "User's Guide"
supplied with the projector.
v Adjusting the Installation Angle
The projection position can be adjusted by tilting or rotating the projector. Adjustment can be done within the following
ranges.
Vertical tilt adjustment: 0 to -8
(sp.15)
If the projector is tilted, the projected image may become distorted into a trapezoidal shape. This distortion can be corrected
by the keystone adjustment. However, if the tilting angle becomes larger, focusing the image becomes difficult. For the details
on the lens shift and keystone adjustment, refer to "User's Guide" supplied with the projector.
Necessary item for the following procedures
Y Ball point hex wrench
When reversing the projected image upside down, select the following from the projector's configuration menu.
[Settings] (or [Extended]) - [Projection]
This setting method may differ depending on projectors. For the details, refer to "User's Guide" supplied with the projector.
14
°
Horizontal rotation adjustment: -3 to 3
(sp.17)
°
Horizontal roll adjustment:
-2.5 to 2.5
(sp.18)
°