Installing The Ceiling Plate Cover - Epson ELPMB30 Manual Del Usuario

Installing the Ceiling Plate Cover

Install the ceiling plate cover after adjusting the installation angles as necessary if you want to coordinate the colors of the
projector and the ceiling.
Necessary items for the following procedure
Y Ceiling plate cover
Procedure
Cutout
Secure this.
Do the same
for the other side.
Y M4x10 screws
(mm; w/o washer)
A
Insert the ceiling plate cover to the rear side.
Use the piece with a cutout to cover the rear side.
B
Insert the M4x10 screws into the screw holes on the ceiling
plate cover and tighten them with the ball point hex wrench.
Y Ball point hex wrench
19