Shifting The Projected Image Up Or Down - Epson ELPMB30 Manual Del Usuario

Shifting the Projected Image Up or Down

Warning
v Keep holding the projector until the installation is complete.
v Do not loosen or remove the screws carelessly during vertical tilt adjustment.
The projector may fall and cause an accident.
v Do not apply extra force to the plate or projector during adjusting the plates.
The projector or plates may fall and cause an accident.
v After the adjustment, try re-tightening all the screws again and make sure that all of them are securely
tightened.
Procedure
Loosen these.
Do the same
for the other side.
A
If the screws are tightened, slightly loosen the four screws
using the ball point hex wrench.
B
Raise or lower the projector manually and roughly adjust the
projection position.
You can fine tune the position downwards in Step 4, so adjust the
position slightly higher at this point of the adjustment.
Support the projector at the angle as it was adjusted until
secured temporarily.
15