Publicidad
6. Route the remainder of the T-Connector assembly to the
right (passenger) side of the vehicle.
7. Remove the connector from the passenger side tail light
housing and insert the T-Connector ends with the green wires
between the seperated ends.
8. Locate a clean accessible mounting location on the vehicle
near the wiring harness ends within reach of the white wire
and grounding eyelet and drill a 7/64" hole.
Caution: Take care not to drill through the body or
any exposed surface.
9. Mount the white wire using the ground screw and eyelet
provided.
10.Confirm trailer harness operation with a test light or by
using a trailer.
11.Secure all wires using cable ties (provided).
12.Re-install both tail light assemblies using the fasteners
removed in step 2 taking care to align the locking clips into
their respective holes
.
Publicidad
