Check Following Assembly - Korg LP-380 Manual De Usuario

5. Insert the pedal unit into the pedal board, and then
fasten it by pressing a push rivet into the hole (above
the cutout) at the rear of the pedal board.
After pressing it into there, lift the pedal board to check
that the pedals do not drop.
The push rivet will prevent the pedal unit from falling
out. Therefore, it cannot be fully fastened to the pedal
board.
Front of pedal board
Rear
Push
Front
6. Temporarily tighten the pedal board, with the pedal
unit fastened, to the hardware inside the side panels
of the stand, using four screws (M4).
Screws
(M4)
7. Raise the assembled stand slowly with two people.
8. Make sure to attach the anti-tipping brackets behind
both side panels. And the anti-tipping bracket fas-
tened to the left of the code holder at this time.
Joints between the side panels and the attached anti-
tipping brackets should be even (with no level differ-
ence left).
Reverse
Cord holder
Screws (M4)
9. Then, firmly tighten all the screws that are temporar-
ily tightened in step 3 and 6.
When tightening the screws on the LP-380, adjust the
up/down and front/rear positions on the left and right
side panels so that they are equal.
18
Rear of pedal board
Push rivet
Screws
(M4)
Anti-tipping
Bracket
Reverse
Screws (M4)
10. Ensure that the stand has no gaps and is not tilted,
and that all the screws are tightened firmly.
11. Put caps on the screw heads on the right and left side
panels.
12. Connect the pedal cord and the speaker cord to the
connectors on the rear of the LP-380's connector box.
When connecting the pedal cord and the speaker cord,
observe the correct orientations of the connectors.
The pedal cord or the speaker cord can be detached
from the connector with its locking tab held down.
Locking tab
Speaker cord
13. Use the cord holder to hold the pedal cord.
After securing the cord with the cord holder, ensure
that excess pressure is not applied to the connectors.
14. Connect the dedicated cord to the AC adapter. Then,
plug the AC adapter into the DC IN connector, and
wrap the cord around the cord hook of the piano. For
details, refer to "Connecting the Power" on page 5.
15. Place the LP-380 where you intend to use it. Make
sure to place it in a safe location where the floor is flat
and stable.
When setting the digital piano in place, make
sure that the stand does not rest on the AC adapt-
er cable or pedal cable.
For greater safety, be sure to attach the anti-tip-
ping brackets to the rear of the left and right side
panels.

Check following assembly

□ Are any parts left over?
If any parts are left over, carefully review the assembly
procedure to see where those parts should have been
used.
□ Make sure that all screws are tight.
Caps
Cord
Pedal cord
holder