Publicidad
Manual RRC-SMB-FPC
RRC SMBUS FLATPAQ C
HARGER
.en
The smart battery charger is used to charge SMBUS batteries (Smart
Batteries) with form factors RRC2130, RRC2140 or smart batteries with
Introduction:
a similar footprint e.g. 21xx range, etc..
Only batteries that comply with the Data Specification 1.0 or 1.1 can be
Caution:
charged with this battery charger. Other rechargeable batteries or
conventional batteries may not be used.
Use smart batteries for as long as possible in your device before
Tip:
recharging. The more completely they are discharged, the more exact
the charger can calculate capacity and charge requirements.
Making Connections
1.
Connect the cable from the mains adapter to the battery charger.
2.
Connect the power cable to the mains adapter and plug it into the mains socket.
3.
The LED is going out after the selftest of the battery charger. The battery charger
is ready for use.
4.
If the red control lamp remains on and no battery is in the charger, the battery
charger is defective.
Charging Batteries
1.
Connect up the battery charger as described above.
2.
Place a discharged Smart Battery into the battery charger.
3.
The battery charger makes a battery recognition and intialisation.
4.
The battery will be charged. Leave the battery until the green control lamp lights.
5.
Then the battery is fully charged. Remove the battery for use.
LED Indications
One time Red/Orange/Green
Self test: Charger is ready for use.
The battery was not recognised as a Smart Battery.
Either a conventional battery is inserted or an
extremely discharged Smart Battery. If it is a
Red/Green blinking
Smart Battery, it will be reactivated within 15
minutes and recharged. If this is not the case, the
LED will light red – see below.
The inserted battery is the correct type and is
Orange light
currently being charged.
Green light
The battery is charged and can be removed for use.
The battery is too hot or too cold to be charged
without damage. If the battery is too cold it will be
Red blinking
charged as soon as it has warmed up sufficiently.
If the battery is too hot it should be removed to
cool down.
Either
- the battery is badly damaged and must be
Red light
replaced, or
- it is a conventional battery which cannot be
recharged.
Device foot assembly
E
2
NGLISH
Manual RRC-SMB-FPC
RRC SMBUS FLATPAQ C
HARGER
Publicidad
