Rotating The Machine Head; Starting Operation - Berner BAG-115-1 Manual Original

OBJ_BUCH-361-002.book Page 24 Tuesday, November 26, 2013 5:58 PM
max.
[mm]
D b
d
115 6
D 125 6
b
D 115
–
125
d
75 30
b
D

Rotating the Machine Head

 Before any work on the machine itself, pull the
mains plug.
ting guide with dust extraction protection guard 20
or for left-handed persons.
Completely unscrew the four screws. Rotate the
machine head carefully, without removing it from
the housing, to the new position. Screw in and
tighten the four screws again.
Operation

Starting Operation

 Observe correct mains voltage! The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Power tools marked with 230 V can also be op-
erated with 220 V.
When operating the machine with power from mo-
bile generators that do not have sufficient reserve
capacity or are not equipped with suitable voltage
control with starting current amplification, loss of
performance or untypical behavior can occur upon
switching on.
24 | English
Please observe the suitability of the power genera-
tor being used, particularly with regard to the mains
[mm] voltage and frequency.
-1 Switching On and Off
d [min ] [m/s]
To start the power tool, push the On/Off switch 4
forwards.
22.2 11000 80
22.2 11000 80 To lock the On/Off switch 4, press the On/Off
switch 4 down at the front until it latches.
To switch off the power tool, release the On/Off
11000 80
switch 4 or, if it is locked, briefly push down the
–
11000 80
back of the On/Off switch 4 and then release it.
To save energy, only switch the power tool on
when using it.
 Check grinding tools before using. The grind-
M 14 11000 45
Kickback stop
(BAG-125-1/BAG-125-1 E)
In case of a sudden drop in speed, e.g., caused by
The machine head
a jammed disc while cutting, the power supply to
can be rotated with
the motor is electronically interrupted.
respect to the ma-
chine housing in 90 °
To restart the operation, switch the On/Off switch
steps. In this manner,
4 to the Off position and start the machine again.
the On/Off switch
Restarting Protection (BAG-125-1/BAG-125-1 E)
can be brought into a
The restarting protection feature prevents uncon-
more convenient po-
trolled restarting of the machine after an interrup-
sition for special
tion in the power supply.
working situations,
To restart the operation, switch the On/Off switch
e. g., for cutting oper-
4 to the Off position and start the machine again.
ations using the cut-
Reduced starting current
(BAG-125-1/BAG-125-1 E)
The electronic reduced starting current limits the
power consumption when switching the tool on
and enables operation from a 13 ampere fuse.
Constant Electronic Control
(BAG-125-1/BAG-125-1 E)
Constant electronic control holds the speed con-
stant at no-load and under load, and ensures uni-
form working performance.
ing tool must be mounted properly and be able
to move freely. Carry out a test run for at least
one minute with no load. Do not use damaged,
out-of-centre or vibrating grinding tools. Dam-
aged grinding tools can burst and cause injuries.
1 609 92A 0ER • 26.11.13