Approved Abrasive Tools; Rotating The Machine Head; Dust/Chip Extraction - Berner BACAGXB 18V Manual Original

Removing the abrasive tool
➊ Open the lever (3).
➋ The grinding/cutting/flap disc will be re-
leased.
➌ The grinding/cutting/flap disc can be re-
moved.
(3)
Cup brushes/disc brushes and fibre discs
Always fit the hand guard (15) when working
u
with the cup brush/disc brush or fibre disc.
See the graphics page for fitting instructions.
To remove an application tool, open the lever (3)
and remove the application tool.

Approved abrasive tools

You can use all the abrasive tools mentioned in
these operating instructions.
The permissible speed [min
tial speed [m/s] of the abrasive tools used must at
least match the values given in the table.
It is therefore important to observe the permiss-
ible rotational/circumferential speed on the label
of the abrasive tool.
max. [mm]
D b
125 7
125 –
75 30
82 –

Rotating the machine head

Remove the battery from the power tool be-
u
fore carrying out work on the power tool (e.g.
1 609 92A 5K8 • 29.6.20
English
(3)
English
English
-1 ] or the circumferen-
[mm]
d [min -1 ] [m/s]
22.2 11,000 80
– 11,000 80
– 11,000 45
– 11,000 80
English
maintenance, changing tool, etc.). The bat-
tery should also be removed for transport and
storage. There is risk of injury from unintention-
ally pressing the on/off switch.
the four screws. Rotate the machine head care-
fully, without removing it from the housing, into
the new position. Screw in and retighten the four
screws.

Dust/Chip Extraction

The dust from materials such as lead paint, some
types of wood, minerals and metal can be harmful
to human health. Touching or breathing in this
dust can trigger allergic reactions and/or cause
respiratory illnesses in the user or in people in the
near vicinity.
Certain dusts, such as oak or beech dust, are
classified as carcinogenic, especially in conjunc-
tion with wood treatment additives (chromate,
wood preservative). Materials containing asbestos
may only be machined by specialists.
– Use a dust extraction system that is suitable for
the material wherever possible.
– Provide good ventilation at the workplace.
– It is advisable to wear a P2 filter class breathing
mask.
The regulations on the material being machined
that apply in the country of use must be observed.
Avoid dust accumulation at the workplace.
u
Dust can easily ignite.
Operation
English
Start-up
English
Inserting the battery
English
Push the charged battery (6) into the base of the
power tool from the front until the battery is se-
curely locked.
Switching on/off
English
To start the power tool, push the on/off switch (5)
forward.
To lock the on/off switch (5) in position, push the
on/off switch (5) forward and down until it clicks
into place.
The machine head can
be rotated in 90° incre-
ments. In this way, the
on/off switch can be
brought into a more fa-
vourable handling posi-
tion for particular ap-
plications, e.g. for left-
handed tool users.
Completely unscrew
English
English | 23