Lenco DAR-070 Manual De Usuario página 16

Pair Bluetooth-enabled Devices
Note:
- The operational range between this unit and a Bluetooth device is approximately 10
meters(without any object between the Bluetooth device and the unit).
Before you connect a Bluetooth device to this unit, ensure that you know the device's
-
capabilities.
- Any obstacle between this unit and the Bluetooth device can reduce e the operational range.
- If the signal strength is weak, your Bluetooth device may disconnect, but it will re-enter
automatically into pairing mode.
1. During ON mode, press the BT button on the remote control to select the Bluetooth mode or
change source to BT by pressing
Bluetoothdevice, the system enters automatically into pairing mode; or you need to press and
hold the PAIR button to start pairing.
Activate the Bluetooth function on your device and select the search mode."Lenco DAR-070"
2.
will appear on your Bluetooth device.
3. To disconnect the Bluetooth function, switch to another function on the unit or disable
thefunction from your Bluetooth device.
Tips:
•
If there is already an existing connection, press the PAIR button to re-activate the
pairingmode. The existing connection will be interrupted.
•
The unit will also be disconnected when your device is moved beyond the operational range.
•
If you want to reconnect your device to this unit, place it within the operational range.
•
If the device is moved beyond the operational range, when it is brought back, check if the
device is still connected to the unit.
•
If the connection is lost, follow the above instructions to pair your device again to the unit.
Listen to Music from Bluetooth Device
- If the connected Bluetooth device supports Advanced Audio Distribution Profile(A2DP), you
can listen to music stored on the device through this unit.
- If the device also supports Audio Video Remote Control Profile(AVRCP), you can use this
unit's remote control to play music stored on the device.
1. Pair your device with this unit.
2. Play music via your device (if it supports A2DP).
3. Use supplied remote control to control play (if it supports AVRCP).
- To pause/resume play, press the
- To skip to a track, press the
1. Press the AUDIO button on the remote control or press the
desired source.
2. Operate your audio device directly for playback features.
3. Press the VOL +/- button to adjust the volume to your desired level.
on the unit. If the unit is not paired to any
button.
or buttons.
AUDIO IN Operation
14
button on the unit to select the