How To Operate Your Ceiling Fan; Important - Fanimation ODYN 84 Manual Del Usuario

How to Operate Your Ceiling Fan

1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Do not operate this fan with a variable (Rheostat)
wall controller or dimmer switch. Doing so could
result in damage to the ceiling fan's remote control
unit.
NOTE: The fan's receiver features an automatic learning
function. There are no frequency switches on the receiver
unit. The receiver will automatically scan the frequency
from the hand held control if any changes are made.
The frequency settings should only be changed in the
case of interference or if multiple ceiling fans with the
same type of control system are installed in the same
structure.
3. To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting process.
If not used for long periods of time, remove battery to
prevent damage to transmitter. Store the remote away
from excessive heat or humidly. (Figure 3)
4. If you have multiple fans and want to program all fans
to one handheld control, connect all fans to their power
supply in the ceiling and follow Step 1 of the remote
control set up process. Each fan needs to be no more than
30 feet from the handheld control that you would like to
program. Please note the wall switch that controls the
power to your fan(s) should be in the off position until you
are ready to program your handheld remote(s).
5. If you have multiple fans and want to program each fan
to separate handheld controls, connect one fan at a time to
their power supply in the ceiling and follow Step 1 of the
remote control set up process below. Before you connect
the second fan to its power supply in the ceiling, you must
disconnect the first fan that was wired and programmed
from the power supply in the ceiling. Repeat these steps
for each fan that you would like to program to a separate
handheld remote. Please note that the wall switch that
controls the power to your fan(s) should be in the off
position until you are ready to program your handheld
remote(s).
All manuals and user guides at all-guides.com
13
For illustrative purposes only-not
intended to cover all types of controls
Figure 1
Figure 2
3V, CR2032
BATTERY
3V CR2032
Battery (2 pcs)
3V, CR2032
BATTERY
Figure 3
MAIN FUSE BOX