Publicidad
Step 17
To insert the drawer into your unit, line up the EXTENSION
å
SLIDES on the drawer with the EXTENSION RAILS on the
unit and push the drawer into the unit until the drawer is fully
inserted. The drawer will push in hard until it is all the way in,
then it will slide in and out easier.
Apply the WARNING LABEL (5L) to the DRAWER
å
BOTTOM (D618). You should be able to read the label when
the drawer is open. When the drawer is closed, it will hide the
label. Peel off the backing and apply the label as shown in
the diagram.
NOTE: This is a permanent label intended to last for the life of
å
the product. Once applied, do not try to remove it.
Push the RUBBER SLEEVES (2R) over the METAL
å
PINS (1R). Insert the METAL PINS into the hole locations of
your choice in the ENDS (A and B). Set the ADJUSTABLE
SHELF (H) onto the METAL PINS.
1R
(4 used)
www.sauder.com/services
2R
5L
Serious or fatal crushing injuries can
occur from furniture tip-over. To help
prevent tip-over:
-Place heaviest items in the lowest drawers.
-Unless specifi cally designed to accommodate,
do not set TVs or other heavy objects on top of
this product.
-Never allow children to climb or hang on
drawers, doors, or shelves.
-Never open more than one drawer at a time.
-If equipped with a drawer interlock system, do not
defeat or remove it.
Use of tip-over restraints may only reduce,
but not eliminate, the risk of tip-over.
No load
B
H
30 lbs.
40 lbs.
D618
40 lbs.
416130
WARNING
A
Page 21
Publicidad
