Publicidad
Step 2
Separate the EXTENSION SLIDES (O) from the
å
EXTENSION RAILS (N) as shown in the lower diagram. Be
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (N) to the ENDS (A and B).
å
Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the innercartridge
of the EXTENSION RAIL in to fi nd the other hole that lines up
with the hole in the END. Turn a SCREW into this hole.
Fasten the ROD HANGERS (7A) to the ENDS (A and B).
å
Use two SILVER 1/2" FLAT HEAD SCREWS (78S).
7A
Page 6
Push the release lever in and pull the SLIDE from the RAIL.
O
SILVER 1/2" FLAT HEAD SCREW
(2 used for the ROD HANGERS)
A
B
Open end
Finished edge
78S
416130
N
Open end
Finished edge
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Publicidad
