Monster Turbine Manual Y Garantía página 8

ENGLISH
Turbine Eartip Fit Testing
®
A good way to gauge whether or not the eartip is sealing properly in your ear
canal is by snapping your fingers right next to your ear. If the seal is proper,
your ear will not feel "plugged, " yet the snapping of your fingers will sound dull
and distant. If you hear your finger snaps distinctly, the seal is probably not
adequate. If the sound of your finger snapping is dull and distant, but your ear
feels plugged up, like you're on an airplane preparing to land, then you've
over-inserted the eartip.
Using Turbine on Flights or At High Altitudes
When using Turbine at different altitudes, the air pressure within your ears may
change, thereby changing the sound that you hear from the headphones. This is
especially true with the gains and drops in altitude during airplane travel. To help
with this, occasionally break the eartip seal and re-insert your Turbine into your
ears. Another helpful tip is the common exercise of holding your nose and very
gently blowing through it, which can relieve some of the pressure in your ears.
Cleaning the Eartips
Keeping your Turbine eartips clean is essential for safe, hygienic use.
IMporTANT: Do NoT attempt to clean the eartips without first removing them
from the Turbine. Getting the delicate circuitry inside your Turbine wet may
cause permanent damage.
11
ENGLISH
1. Firmly grip the eartip with one hand and the earphone with the other.
Carefully remove the eartip from the eartube.
2. Use warm water and mild soap on a damp cloth to remove dirt and earwax
from the eartip. Do NoT use harsh cleaning agents.
3. Rinse and completely dry your eartips before placing them back on your Turbine ® .
4. Carefully push the eartips back onto the Turbine, making sure they are
on the eartube completely.
Using The Cable Management Clip
The Cable Management Clip is designed to control the cable and keep it out of your
way, reduce accidental pulling of the in-ear speakers from your ears, and keep
the cable weight off the in-ear speakers so they stay snug and in place in your ears.
1. Put Turbine In-Ear Speaker into your ears, as you usually would when listening.
™
2. Fasten the Cable Management Clip onto your shirt
around the chest or collar area, wherever is most
convenient for the shirt you're wearing.
3. Grab the cable above the Cable Management Clip
and pull it slightly upward, sliding it through the clip
to create enough slack between the in-ear speakers
and clip to allow for head movement and to take
the stress off the in-ear speakers.
12