3M PELTOR TEP-300 Manual Del Usuario página 9

7. TO CHARGE THE PRODUCT
7.1. BATTERY NOTE
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or rechargeable batteries.
• To properly dispose of the AA/AAA batteries, follow local
solid waste disposal regulations.
7.2. CHARGING
Note: The charging case prevents charging in temperatures
above 113°F/45°C or below 32°F/0°C.
The 3M™ PELTOR™ TEP-300 Earplugs should be charged
before first use. The product will indicate low battery status
with an audio message "low battery", when less than one hour
of battery life remains. The audio message will repeat every
five minutes.
The TEP-300 earpieces are charged inside the charging case
using 3 AA or AAA (using the AAA battery adaptor) batteries or
using a USB-C cord (not provided).
7.3. CHARGING USING AA OR AAA BATTERIES
1. Lift the latch to open the lid of the charging case.
2. Open battery lid of the battery compartment of the charging
case.
3. Insert 3 AA batteries. Make sure the (+)(-) poles are aligned
according to the diagram on the charging case.
4. Close the battery lid of the battery compartment.
5. Align the charging contacts on the earpiece and charging
receptable inside the case.
6. Insert the narrow end of the earpiece first.
7. Gently press and snap the earpiece into the receptable.
Note: The earpiece will start to charge automatically.
8. Repeat for the second earpiece.
9. Press the test/status button on the charging case to view the
charging status.
Light Cause
Solid Red Charging
Blinking Red Not Charging
Fast Blinking Red Temperature Fault
Solid Yellow Charging – low battery
Blinking Yellow Not charging – low battery
Solid Green Charging Complete
Note: Charging time is approximately 90 minutes.
10. To remove the earpiece from the charging unit, gently lift up
on the earpiece while holding on to the charging case.
7.3.1. TO USE THE AAA BATTERY ADAPTER
1. Fold the AAA battery adapter according to the illustration.
EN
4