EdilKamin ALPEN Instalacion Uso Mantenimiento página 33

COVERING INSTALLATION ANDE/FUJI
27
g. 1
6
114 -115
g. 3
g. 5
72
g. 6
6
70
g. 8
12
19
72
72
g. 10
6
g. 2
g. 4
150
150
114
115
150
150
114
115
150 150
detail "Y"
g. 7
150
150
70
70
150
150
70
70
150
150
g. 9
DETAIL. Z
Part. "Z"
72
bushings
12
vite
screw
g. 11
INCLUDED HARDWARE:
2 M6x25 screws
2 M6x12 screws
4 silicone spacers for ceramic top
8 at washers M6
2 bushings
NR 16 silicone spacers for ceramics
ASSEMBLING THE LATERAL TILES ( g. 1-2)
• Remove the rear panel (27).
for the FUJI model ( g. 3-4)
• Fit the ceramic tiles (114-115) onto the plates (6).
• Insert 2 silicone spacers (150) in the back part between the
cast-iron base and the lower right tile (115) see part. Y - g. 4.
• For correct fastening of the upper right side ceramic tile and
the lower left side ceramic tile use the stop adjustment screws
located on the zinc-plated sides of the structure (Illustr. 5-6)
• Right-hand side (Illustr. 5): adjust the xing screw abutted
against the upper right side ceramic tile (114).
• Left-hand side (Illustr. 6): remove the upper left ceramic tile
(115) and adjust the xing screw abutted against the lower left
side ceramic tile (114).
• Replace the upper left ceramic tile (115).
for the ANDE model ( g. 8-9)
• Fit the ceramic tiles (70) onto the plates (6)
NOTE: Being made through a process of casting,the tiles may
differ slightly in height. To compensate for any height vari-
ations, silicone spacers may be inserted (150 - g. 4-9) without
affecting the aesthetic appearance of the stove.
• Replace the rear panel (27).
ASSEMBLING THE UPPER FRONT PANEL ANDE/
FUJI ( g. 10-11)
• Extract the cast iron upper grille (19), by pulling it upwards,
and position the upper front panel (72) against the metallic
front panel support (12) located above the door.
• Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws (the door must be opened before
performing this operation).
NOTE:
In order to correctly install the upper front panel (72), the
supplied bushing must be positioned between it and the
metallic front panel (12), as indicated in detail "Z" ( g. 11).
ASSEMBLING THE LOWER FRONT PANEL ANDE/
FUJI ( g. 10-12)
• Position the lower front panel (72) and use an Allen key
to fasten it in place using the 2 supplied M6x12 screws
as indicated in detail "X" ( g. 12).
- 33
-