Electrical Characteristics - EdilKamin ALPEN Instalacion Uso Mantenimiento

TECHNICALAND HEATING SPECIFICATIONS
Rated power
Water heating power
Approx. overall ef ciency
CO emission (13% O2)
Max. pressure
Operating pressure
Smoke output temperature from test EN 4785/303/5
Minimum draught
Min./max. autonomy
Fuel consumption min./max.
Hopper capacity
Heating capacity
Weight including packing ALPEN / ANDE / FUJI / URAL
Diameter of smoke extract duct male thread (male)
Air intake pipe diameter (male)
* The heatable room dimensions are calculated on the basis home insulation in compliance with Italian law 10/91, and subsequent
changes together with an expected heat output of 33 Kcal/m³ per hour.

ELECTRICAL CHARACTERISTICS

Power supply
On/off switch
Average power consumption
Power consumption during ignition
Remote control frequency
Protection on mains power supply
Protection on electronic circuit board
N.B.
1) keep in mind that external devices can cause interference to the operation of the circuit board.
2) caution: live parts. Servicing and/or inspections must be carried out by quali ed staff.
(Before carrying out any maintenance, disconnect the device from the mains power supply)
The data shown above is purely indicative.
EDILKAMIN s.p.a. reserves the right to change the products at its discretion without notice.
FEATURES
(see page 27)
in accordance with EN 14785
305 / 325 / 325 / 270
230Vac +/- 10% 50 Hz
yes
120 W
400 W
Infrared
Fuse 2AT, 250 Vac 5x20
Fuse 2AT, 250 Vac 5x20
- 29
-
18 kW
16 kW
91,9 %
0,015 %
3 bar
1,5 bar
127,5 °C
12 Pa
5,5 / 19 hores
1,2 / 4,1 kg/h
26 kg
470 m³
kg
80 mm
50 mm