Remote Control; Low Battery Indicator - EdilKamin ALPEN Instalacion Uso Mantenimiento

REMOTE CONTROL

This controls all the functions. It is necessary to point it directly
at the boiler-stove.
For further information contact our customer service centre.
Key to buttons and display:
: ignition / shutdown button
+/- : to increase/decrease the various regulations
A : button to switch to the "EASY TIMER " program
M : key for viewing/setting the set temperature (Set 70°C)
Indicates data transmission between the remote control
and the control board.
blocked keypad; avoid turning on the remote control
for no reason (press "A" and "M" simultaneously for a
few seconds to block/unblock the keypad)
low batteries; replace them and put them in their ap-
propriate containers.
Indicates that ignition / shutdown is being via the
"EASY TIMER" program
Indicates the room temperature detected by the
remote control (it indicates the values of the set
parameters during its technical set-up).
On icon: boiler-stove in start-up/operating phase
pellet/water boiler-stove remote control setting
indicator
Indicates that the boiler-stove is operating in automatic
mode
INSTRUCTIONS FOR USE
- 39
USING THE "EASY TIMER" PROGRAM
The new remote control allows you to manage a timer program
that is very intuitive and easy to use:
- If the boiler-stove is on: a delayed shutdown can be set from
the remote control - from one to twelve hours. The remaining
time for the scheduled shutdown is shown on the display of the
synoptic panel.
- If the boiler-stove is off: a delayed ignition can be set from
the remote control - from one to twelve hours. The remaining
time for the scheduled ignition is shown on the display of the
synoptic panel.
- Setting: proceed as follows to set the timer:
a) Press the "A" button and the icon
display, thereby con rming the "Easy timer" program has been
accessed.
b) Set the hours by pressing the +/- buttons, for example:
c)Point the remote control towards the synoptic panel receiver
d) Con rm the setting by pressing the "A" button for a few
seconds; the icon will go off and the remaining time will ap-
pear on the synoptic panel after which the "Easy timer" setting
will intervene.
e) Repeat points a), b), c), d) to cancel the setting, and set the
hours to "00H"
BLOCKED KEYPAD
The remote control buttons can be blocked so as to prevent it
from going on accidentally.
Press the A and M buttons simultaneously and the key symbol
will light up con rming that the keys have been blocked.
Press the A and M buttons simultaneously once again to
unblock the keypad.

LOW BATTERY INDICATOR

When the battery icon lights up it indicates that the batteries
inside the remote control are almost at.
Replace them with three new batteries of the same model (size
AAA 1.5V).
- Do not use new batteries with used ones.
- Do not mix brands and different types as every type and
brand has a different capacity.
- Do not mix traditional batteries with rechargeable ones;
- Do not try recharging alkaline and zinc-carbon batteries as
this can cause them to break and/or a liquid leakage.
-
will light up on the