EdilKamin ALPEN Instalacion Uso Mantenimiento página 34

COVERING INSTALLATION ANDE/FUJI
72
2 screws n°2 viti
DETAIL. X
Part. "X"
g. 12
COVERING INSTALLATION URAL
g. 1
DETAIL. Z
Part. "Z"
72
72
bushings
12
vite
screw
g. 8
*
g. 4
73
*
12
19
72
72
72
2 screws n°2 viti
DETAIL. X
Part. "X"
g. 9
90
ASSEMBLING THE CERAMIC TOP ANDE/FUJI ( g. 13)
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (73)
• if necessary, insert a washer between the silicone spacer
and the cast iron top.
NOTE:
• the red enamel with crystalline, applied to the
majolica, crazes (cracks) evenly over the whole surface.
Crazing is not a defect but is a characteristic of enamel
applied to majolica known as "craclè".
g. 13
• The ceramic parts (majolica) are cast and enamelled
manually and may present small defects that will not
affect their quality (small dents or enamel porosity), but instead
testi es to their manual manufacture.
INCLUDED HARDWARE:
2 M6x25 screws
2 M6x12 screws
4 silicone spacers for ceramic top
8 at washers M6
2 bushings
The thermo-stove comes furnished with its lateral metal
side panels already assembled, while its ceramic upper
and lower front panels (72) and top (90) must be assembled
as follows:
ASSEMBLING THE UPPER FRONT PANEL ( g. 1-2)
• Pull the cast iron upper grille upwards (19).
• Position the upper front panel (72) against the metallic
front panel support (12) located above the door.
• Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws (the door must be opened before
performing this operation).
NOTE:
In order to correctly install the upper front panel (72), the
supplied bushing must be positioned between it and the
metallic front panel (12), as indicated in detail "Z" ( g. 2).
ASSEMBLING THE LOWER FRONT PANEL ( g. 1-3)
• Position the front panel (72) and use an Allen key to
fasten it in place using the 2 supplied M6x25 screws as indica-
ted in detail "X" ( g. 3).
ASSEMBLING THE CERAMIC TOP ( g. 4)
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (90)
• Where necessary, af x the supplied washer between the silic-
one spacer and cast iron top.
- 34
-