Keypad, Modes, And Led - Stanley 4V1H Multi Manual De Instrucciones

• Do not place the laser in a position which may
cause anyone to intentionally or unintentionally
stare into the laser beam. Serious eye injury
could result.
• Do not position the laser near a reflective
surface which may reflect the laser beam toward
anyone's eyes. Serious eye injury could result.
• Store an idle laser out of reach of children and
other untrained persons. Lasers are dangerous in
the hands of untrained users.
• Turn the laser off when it is not in use. Leaving
the laser on increases the risk of staring into the
laser beam.
• Do not modify the laser in any way. Modifying
the tool may result in hazardous laser radiation
exposure.
• Do not operate the laser around children or
allow children to operate the laser. Serious eye
injury may result.
• Do not remove or deface warning labels. If labels
are removed, the user or others may inadvertently
expose themselves to radiation.
• Position the laser securely on a level surface. If
the laser falls, damage to the laser or serious injury
could result.
Personal Safety
• Stay alert, watch what you are doing, and use
common sense when operating the laser. Do not
use the laser when you are tired or under the
influence of drugs, alcohol, or medication. A moment
of inattention while operating the laser may result in
serious personal injury.
• Use personal protective equipment. Always wear
eye protection. Depending on the work conditions,
wearing protective equipment such as a dust
mask, non-skid safety shoes, hard hat, and hearing
protection will reduce personal injury.
Tool Use and Care
• Do not use the laser if the Power button does
not turn the laser on or off. Any tool that cannot be
controlled with the switch is dangerous and must
be repaired.
• Follow instructions in the Maintenance and Care
section of this manual. Use of unauthorized parts or
failure to follow Maintenance and Care instructions
may create a risk of electric shock or injury.

Keypad, Modes, and LED

Keypad and Laser Modes (Figure Ⓒ)
Power ON / OFF key
Pendulum Lock Switch (Figure Ⓓ)
Pendulum lock off / Self-leveling on
Pendulum lock on / Self-leveling off
ALWAYS slide the pendulum lock switch to the
LOCKED position when the laser is not in use.
(Figure Ⓓ ①)
Modes
Laser Beam Available Modes.
See Figures Ⓑ and Ⓒ for beam configuration.
Self-Leveling
• The pendulum lock on the laser tool needs to be
switched to the UNLOCKED position to enable
self‑leveling when placed in a position < 4°.
Out of Level
• If the laser has been tilted > 4° then it cannot
self‑level and the laser beam will flash.
Keypad - Pulse Mode (Figure Ⓒ ②)
Pulse mode ON / OFF key
Press to activate Pulse mode, LED on.
Press again, Pulse mode off, LED off.
GB
9