Spare Parts - Far Tools CM 250 Manual De Instrucciones

Maintenance :
Before doing any maintenance work inside the machine switch off and lock the main switch and disconnect
the power supply from the machine.
The machine should be cleaned and the rods, pins, threads and other parts liable to corrosion should be
lubricated with a suitable oil.The interval for such activities will depend on the manner of work but it should
be performed at least once a month
The bearings of the electric motors, moulding spindle and circular saw shafts have permanent grease filling,
are closed on both sides and do not require any lubrication.
Clean the tables from resin with a suitable solvant
Avoid contamination of belts with oil or grease. If this occurs, clean the belt with paper only or dry it.
Removing the dust is best to be done with a vaccuum cleaner.
Troubleshooting :
Before starting maintenance or repair work always disconnect the machine from the mains !
The machine does not work : It will be necessary to check the electrical wiring and connection of the
machine to the mains.
The thicknessing table moves with difficulties :The table fixing lever should be released or the co-
lumn should be lubricated
The machine output is low : Tools are not sharp, teh V-belt is not tightened enough, The motor does
not work with the full power output - an expert should be called
the machine vibrates : Tools are not sharp or adjusted properly, The knives are of different width,
unbalanced tools, The machine is not standing on a flat ground, is not anchored properly.

Spare parts:

For order of spare parts, please use following exploded views:
Consultings :
we recommend the acquisition of a practical guide for a better use of all functions of your machine
113752-Manuel-A-EN .indd 29
F
10/04/07 16:13:38