Kohler K-702210 Guia De Instalacion página 12

Align groove in
header with tab
on side panel.
Align groove
in header with
tab on door.
10. Install the Header
Non-Steam Door
Insert the header expander into the header.
Position the header on top of the door and side panel (if applicable). Slide the header between the
expander jambs, making sure the groove in the header aligns with the tabs on the door and side
panel top, or sits level on top of the strike jamb if the side panel is not used.
NOTE: Make sure the Kohler logo on the side of the header faces outward.
Fasten the header in place using the pre-drilled hole in the expander jamb as a guide. If there are no
pre-drilled holes, drill a hole 1/2" (1.3 cm) from the top of each expander jamb using a 9/64" drill
bit.
Using the pre-drilled hole as a guide, drill through the header using a 9/64" drill bit. Secure the
header to the expander jamb using two #8 x 5/8" screws.
Steam Door
The header is already in place.
Slide the header down while holding the header expander against the ceiling. Make sure the groove
in the header aligns with the tabs on the door and the side panel, or sits level on top of the strike
jamb if there is no side panel.
Fasten the header in place using the pre-drilled hole in the expander jamb as a guide. If there are no
pre-drilled holes, drill a hole 1/2" (1.3 cm) from the top of each expander jamb using a 9/64" drill
bit.
Using the pre-drilled hole as a guide, drill through the header using a 9/64" drill bit. Secure the
header to the expander jamb using two #8 x 5/8" screws.
1015287-2-B
Header
As viewed from
inside the shower.
12
#8 x 5/8"
Panhead Screw
Kohler Co.