GiBiDi BA230 Manual De Instrucciones página 23

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 66
BA230
Control unit
Type
Power supply
N° motors
Motor power supply
Flashing light
Warning light
Electric lock
Accessory power supply
Safety device power supply
Radio receiver
Operating temperature
Operating time
TECHNICAL SPECIFICATIONS / FUNCTIONS
• Times self-learning.
• Red warning leds of n.c. contacts. There is not the safety devices led (ex. edge), the possible anomaly is
indicated by the writing SAF on the LCD.
• Green warning leds of n.o. contacts.
• Two independent 12Vdc electrical locks management.
• Management of courtesy light with 12 Vdc or 230 Vac output.
• Safety test run before the opening and closing movement.
• Photocell 1 test run before the opening and closing movement.
• Stop and motion inversion for 2 s after the intervention of the safety devices. At the next start pulse, the motion
restarts in the obstacle freeing direction.
• SEPARATE SAFETY DEVICES POWER SUPPLY. The connection to this power supply will allow the TEST of
the devices before the motion. Connect to this clamp the safety devices that will be supplied only during the o
perating cycle.
• Digital programming of all functions.
• Working time adjustable independently in opening and closing for each single motor.
• Deceleration time adjustable independently in opening and closing for each single motor in the motion final
phase (soft-stop).
• Gate phase shift time adjustable independently in opening and closing.
• Adjustable pedestrian working time.
• Adjustable and differentiated pause time for complete or pedestrian opening.
• Adjustable thrust force with 3 modalities on 10 levels for each motor.
• Selectable and independently adjustable decelerations with 3 modalities on 10 levels for each motor.
• Decelerations enabling with single or double limit switch.
• 4 possible working functions (step-by-step, step-by-step with stop, condominium or automatic, dead man).
• Possibility of choosing the system configuration from swing gate, overhead/barrier and sliding gate, single our
double.
• SAFETY DEVICE choice with N.C. contact or 8K2 resistive.
• Specific menu for the exclusion of the accessories not used (photocell 1, photocell 2 and safety devices).
BA230 / AS05550
Electronic control unit for the automation
of one or two 230V motors for swinging and sliding gates,
overhead doors and barriers
230Vac monophase 50/60 Hz
230Vac 40W max
24Vdc 3W max
12Vdc 15W max
24Vdc 8W max including safety devices power supply
24Vdc 8W max including accessories power supply
-20°C +60°C
1 or 2
230Vac
Plug-in
300s max
23
UK

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

As05550

Tabla de contenido