GiBiDi BA230 Manual De Instrucciones página 27

BA230
PROGRAMMING PROCEDURE AND SYSTEM CONFIGURATION
The system adjustments can be accessed via the display. There are 5 different menus marked with the letters A,
C, F , H and E.
Gbd
-
ESC
PASS
-
ESC
0 0 0 0
-
ESC
4 0 0 0
-
ESC
4 6 0 0
-
ESC
1
To enter the programming procedure, start from the display as
shown in the picture and press simultaneously the keys ESC and
OK for 3 s (The writing Gbd will turn off)
+
OK
Go to step 2.
2
The writing P A S S appears on the display.
Press the OK key to go to step 3.
Pressing simultaneously the keys + and - for 3 s, all default settings
will be loaded (only the performed cycles settings remain stored).
Press the ESC key to go back to step 1.
+
OK
3 3
4 figures appear on the display ( 0 0 0 0 ), the first one is flashing.
With the + or – keys, the user selects the first digit of the installer
code.
When the required digit is selected, presso OK to confirm and go to
+
OK
step 4.
4
The second figure is flashing.
With the + or – keys, the user selects the second digit of the installer
code.
When the required digit is selected, press OK to confirm and go to
+
OK
step 5.
5
The third digit is flashing.
With the + or – keys, the user selects the third digit of the installer
code.
When the required digit is selected, press OK to confirm and go to
step 6.
+
OK
27
UK