GiBiDi BA230 Manual De Instrucciones página 31

BA230
E 3
-
ESC
A C F H E
-
ESC
Gbd
-
ESC
MENU A: SYSTEM CONFIGURATION AND OPERATING LOGIC SELECTION
KEY + enters the following menu A1-A2-A3-...
KEY – enters the previous menu A3-A2-A1...
KEY ESC leaves the menu
KEY OK enables Y (yes). It enables the function and automatically disables the complementary function
(example; the activation of A4 = 1 motor automatically disables A5 = 2 motors)
Menu Function
SWING /
A2
OVERHEAD DOOR / BARRIER
A3
SLIDING GATE
A4
1 MOTOR CONFIGURATION
23
E3 = SAFETY DEVICE (EDGE)
Y
Press OK in sequence to:
Enable the input (the Y will appear next to E3)
Disable the input (the N will appear next to E3)
+ Use the + and – keys to enter the following or the previous menu.
OK
Press ESC to leave the menu; "ACFHE" is now shown on the display.
24
Press ESC to store the settings and leave the programming phase,
accessing normal operation.
+
OK
25
The starting symbols reappear on the LCD.
At this point, the +, - and OK keys mean:
+
+
-
OK
OK
Status Description
It configures the system for swing gate, overhead door or barrier.
Y
The activation of this menu automatically disables A3.
It configures the system for a sliding gate.
This configuration automatically excludes:
gate phase shifts in opening and closing
hammer stroke
2 s opening and closing final stroke
Y
T3 additional time
NOTE: the limit switches are NOT activated automatically, choose the
required configuration with menu C5
The activation of this menu automatically disables A2.
It configures the system for 1 motor.
In the menu C11 it will be possible to set the courtesy light output:
N = courtesy light disabled
Y1 = courtesy light on MOTOR 2 output (diagram output 230 Vac) (3)
Y
Y2 = courtesy light on ELECTRIC LOCK 2 output (see diagram 12 Vdc
The courtesy light output is 3-minutes timed.
The activation of this menu automatically disables A5.
START
PEDONALE
STOP
output)
31
UK