Kit Preparation; Kit Assembly - Metra 95-5844S Instrucciones De Instalación

KIT PREPARATION

1. Place the radio trim panel into the
factory dash panel and secure with
the (7) T-20 screws and (4) push nuts
removed in Dash Disassembly. (Metra
recommends a small 8mm socket for
pressing them on). (Figure A)
2. Mount the pocket, climate controls and
buttons to the Metra radio trim panel
using the factory hardware. (Figure B)
Continue to Kit Assembly
(Figure A)
(Figure B)

KIT ASSEMBLY

1. Attach the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
3. Secure the radio into the dash opening
using the factory hardware.
4. Snap the radio trim panel over the radio
and then reassemble the dash in reverse
order of disassembly.
(Figure A)
REV. 5/14/2018 INST95-5844S
3