Making Coffee With Ground Coffee - Princess 249402 Manual De Instrucciones

Only use the amount of water required for
making the coffee. The appliance
automatically stops when the water
reservoir is empty.
• Open the cover (26).
• Fill the coffee bean compartment (13)
completely with coffee beans.
• Close the cover (26).
• Set the ground coffee fineness. Refer to the
section "Setting the ground coffee fineness".
• Press the release button (12) to open the
filter holder assembly (11).
• Place a suitable coffee filter in the coffee
filter holder (10).
• Close the filter holder assembly (11) until
the release button (12) clicks into place.
Note: The appliance can only be used when
the display is activated. If the display is not
activated, press any button to activate the
display. The appliance is ready for use.
• Set the coffee quantity. Refer to the section
"Setting the coffee quantity".
• Set the coffee strength. Refer to the section
"Setting the coffee strength".
• Place the coffee pot (16) on the heating
plate (18).
• Switch on the appliance by pressing the
on/off button (1). The cup-of-coffee symbol
(E) starts flashing. After a few seconds, the
appliance starts grinding the coffee beans
and making the coffee.
• To interrupt the process, press the on/off
button (1).
• If the process is completed, the appliance
will beep and switch to keep-warm mode.
The cup-of-coffee symbol (E) stops flashing.
The appliance can be switched off by pressing
the on/off button (1) or the appliance
switches off automatically after ½ hours.
• Allow the appliance to cool down completely.

Making coffee with ground coffee

(fig. A, B, C, D & G)
Before you proceed, we would like you to
focus your attention on the following notes:
- Only use ground coffee that is suitable for
the appliance.
- Only use paper coffee filters (1x4) that are
suitable for the appliance.
• If the grinding function is activated, press
the grinding button (2) to deactivate the
grinding function. The coffee quantity and
the coffee strength are not shown on the
display.
• Fill the water reservoir (14) with the
required amount of water.
• Do not fill the water reservoir with more
water than required for making the coffee.
Only use the amount of water required for
making the coffee. The appliance
automatically stops when the water
reservoir is empty.
• Press the release button (12) to open the
filter holder assembly (11).
• Place a suitable coffee filter in the coffee
filter holder (10).
• Put the required amount of coffee in the
coffee filter.
• Close the filter holder assembly (11) until
the release button (12) clicks into place.
• Place the coffee pot (16) on the heating
plate (18).
Note: The appliance can only be used when
the display is activated. If the display is not
activated, press any button to activate the
display. The appliance is ready for use.
• Switch on the appliance by pressing the
on/off button (1). The cup-of-coffee symbol
(E) starts flashing. The appliance starts
making the coffee.
• To interrupt the process, press the on/off
button (1).
• If the process is completed, the appliance
will beep and switch to keep-warm mode.
The cup-of-coffee symbol (E) stops flashing.
The appliance can be switched off by pressing
the on/off button (1) or the appliance
switches off automatically after ½ hours.
• Allow the appliance to cool down completely.
Delay start function (fig. B & C)
The appliance has a delay start function which
makes it possible to program the time for
starting the coffee-making process.
Note: The appliance can only be used when
the display is activated. If the display is not
activated, press any button to activate the
display. The appliance is ready for use.
15