Functional Description; Extent Of The Delivery; Use; Assembling Instructions - Grizzly ERT 450/8 Traducción Del Manual De Instrucciones Original

cord diameter of the extension cable
must be at least 2.5 mm
a cable drum to its full length so that the
entire cable can be inspected for dam-
age.
• Never pass an operating equipment
over the extension cable. Ensure that
the power cable is always trailing be-
hind the operator. The extension cable
can be accidentally severed.
• Use the envisaged cable suspensions
when attaching an extension cable.
• Never carry the equipment by its power
cable. Never pull the cable to discon-
nect the plug from the mains socket.
Protect the cable from heat, oil and
sharp edges. The mains power cable
could be damaged.

Functional description

The portable, hand-guided lawn trimmer is
powered by an electric motor. The trimmer
features a dual line spool as the cutting
device.
For grass trimming there are two nylon
lines rotating parallel with ground level.
An additional chassis facilitates edge trim-
ming. A hood covering the cutting device
protects the user.
The following describes the functions of
the operating parts.

Extent of the delivery

Carefully unpack the trimmer and check
that it is complete:
• Lawn trimmer
• Protective cover with 1 cover moun-
ting screw .
• Additional handle
• Instruction Manual
. Always unreel
2

Use

The trimmer is solely intended for cutting
grass and weeds in the garden and for
edge trimming. Any other use that is not
specifically approved in these Instructions
can result in damage to the trimmer and
give rise to serious danger for the user.
Do not use the appliance to trim hedges or
bushes.
This equipment is not suitable for commer-
cial use. Commercial use will invalidate the
guarantee.
The trimmer must only be used by adults.
Young people aged 16 and over may only
use the trimmer under adult supervision.
The manufacturer cannot be held liable
for damage when the trimmer is not used
in conformity with its intended purpose or
due to incorrect operation.

Assembling instructions

Always disconnect the plug be-
fore working on the trimmer and
wait until the cutting lines have
completely stopped. There is the
danger of electric shock and the
possibility of injury by the cutting
lines.
1. Carefully unpack the trimmer
and check that it is complete:
Assembling the protection
cover:
2. Flap the protective cover (10)
open.
3. Place the protective cover (10)
in the guide and turn it anti-
clockwise by 90° up to the stop
( mark).
ê
4. Use the screw from the package
to secure the cover.
UK
109