Operation; Switching On And Off; Trimmer Settings - Grizzly ERT 450/8 Traducción Del Manual De Instrucciones Original

UK
Mounting the additional handle:
5. Plug the two black handle rod
discs (14) into the rod openings
(15).
6. Pull the ends of the auxiliary
handle (5) to extend the handle
and slide it over the handle rod
discs.
7. Screw down the auxiliary

Operation

Never use the trimmer without its
protective cover. Always check
the operability of the trimmer
before it is used. Check that the
mains voltage is the same as
indicated on the rating plate. Al-
ways wear goggles when work-
ing with the trimmer.
Please observe local regulations
concerning noise protection. Use
of the appliance may be restricted
or prohibited on certain days
(Sundays, holidays, etc.), at certain
times (early afternoons, at night,
etc.) or in certain areas (health re-
sorts, clinics,

Switching ON and OFF

1. Form a loop in the end of the ex-
tension cable, conduct it through
the opening in the upper handle
and hang it on to the strain relief
(4).
2. Connect the trimmer to the
mains socket.
3. Ensure a safe stance and hold
the equipment firmly with both
hands. Do not deposit the cutting
head on the ground.
4. To switch on depress the ON
110
handle.
etc.).
/ OFF switch (3). Release the
switch to switch off.
After the trimmer has been
switched off the cutting head will
continue to rotate for a few sec-
onds. Keep hands and feet well
away.
The ON / OFF switch must not
be locked in place. The trimmer
must not be used if the switch is
damaged. There is the immedi-
ate danger of injury if the motor
does not switch off after the ON /
OFF switch has been released.
Caution: Always remove grass
residue from the line cutter so that
the cutting effect is not impaired.

Trimmer settings

Adjusting the additional handle:
The additional handle can be set in dif-
ferent positions. Set the handle in such a
manner that the cutting head is slightly tilt-
ing forwards when in the working position.

Release the knurled nut (16) and
adjust the additional handle (5) in
the required position. Retighten the
knurled nut.
Adjusting the height:
The telescopic tube enables you to adjust
the trimmer to your height.
‚
Release the screw sleeve (7). Adjust
the telescopic tube (8) to the required
length and retighten the screw sleeve.
To adjust the handle rod:
The handle rod turns by 90° and 180°.