Checks On The Gate; Preparation Of The Installation Site - Allmatic Hyper 400 Manual Del Usuario

2 3 4 5

5.1 CHECKS ON THE GATE

Before proceeding to the installation of the motor it is recommended to check the following on the gate:
• The gate must be level
• The gate must be in good condition
• The gate must not have protuberances that collide with the ground or other objects
• The gate must not hit or crawl the ground at any point of the race
• The gate must be easily opened and closed for the full width of its run and must be supported only by its hinges
• The gate must meet the weight and size requirements indicated in this manual

5.2 PREPARATION OF THE INSTALLATION SITE

2 3 4 5
Prepare on the installation site the ducts for the passage of motor cables.
The cables for the connection of the various devices in a typical plant are listed in the table below and must be suitable for the type
of installation, for example we recommend a cable type H07RN-F for outdoor installation.
TABLE 6 - Cables to be used
CONNECTION
Power supply line
Motor
Flashing light
Photocell - transmitter
Photocell - receiver
Key selector
* If the cable exceeds 10 m, a cable with a larger section must be used and a safety grounding must be installed near the auto-
mation.
6-1624982 - rev.3 - 03/11/2021
6 7 8 9
6 7 8 9
CABLE
3 x 1,5mm²
4 x 1,5mm²
2 x 0,5mm²
2 x 0,5mm²
4 x 0,5mm²
4 x 0,5mm²
10 11 12 13
10 11 12 13
DUCT
MAXIMUM LENGTH
20 m *
10 m *
20 m
20 m
20 m
20 m
14 15 16 17
14 15 16 17
English - 9
18
IRD Data/date Disegnatore/designer
MATER
altern
TRATTA
Progetto/Project:
Via dell'Artigianato 1
DENOM
32026 -Borgo Valbelluna (Bl)
tel. +39 0437 751175 fax +39 0437 751165
info@allmatic.com - www.allmatic.com
Al
Il presente disegno è di proprietà della
18