Control Unit; Maintenance; Product Disposal; Warranty - Allmatic Hyper 400 Manual Del Usuario

6.6 CONNECTION TO THE CONTROL UNIT
Make connections to the control unit only in the absence of power supply.
For the 230Vac and 120Vac gearmotors, install the capacitor supplied between Phase 1 and Phase 2 of the motor.
Please refer to the installation manual of the control unit for the connection diagram.
TABLE 9 - Cable colour for 230Vac motor
COLOUR
Black
Brown
Grey or Blue
Yellow / Green

7. MAINTENANCE

For the correct maintenance of the automation, make sure to perform at least once every 6 months the following steps:
1. Check that all the fixing screws of the brackets are tight.
2. Check that the gate is in good condition and that there are no broken or worn parts.
3. Check the status of the electrical connections and in case of wear of the cables replace them.
4. Unlock the motor and move the gate manually by checking that the movement is fluid. In case it is necessary to
put a layer of lubricating grease on the stem.

8. PRODUCT DISPOSAL

This product is an integral part of automation, and therefore must be disposed of together with it. As with installation operations, even
at the end of the life of this product, dismantling operations must be carried out by qualified personnel. This product consists of various
types of materials: some can be recycled, others must be disposed of. Find out about the recycling or disposal systems required by the
regulations in force in your territory for this category of product.
WARNING! - certain parts of the product may contain pollutants or dangerous substances which, if dispersed in the
environment, could have harmful effects on the environment and human health.
As indicated by the symbol on the side, it is forbidden to throw this product into household waste. Then perform the
"separate collection" for disposal, according to the methods provided by the regulations in force in your territory, or
return the product to the seller when buying a new equivalent product.
WARNING! - the regulations in force at local level may provide for heavy penalties in case of improper disposal of this
product.

9. WARRANTY

The manufacturer's warranty is valid from the date stamped on the product and is limited to the repair or replacement free of charge
of the parts recognized by the same as defective due to lack of essential quality in the materials or lack of processing. The warranty
does not cover damage or defects due to external agents, maintenance deficiency, overload, natural wear, choice of incorrect type,
assembly error, or other causes not attributable to the manufacturer. Tampered products will not be guaranteed or repaired. The data
given are purely indicative. No liability may be charged for reductions in scope or malfunctions due to environmental interference.
The liability of the manufacturer for damage caused to anyone by accidents of any nature caused by our defective products, are only
those that derive from the Italian law.
6-1624982 - rev.3 - 03/11/2021
DESCRIPTION
Phase 1
Phase 2
Neutral
Ground
CAPACITOR
M
GROUND
PHASE 1
PHASE 2

CONTROL UNIT

NEUTRAL
English - 15