General Warnings - Allmatic BIOS2 24V Manual Del Usuario

1 - GENERAL WARNINGS

WARNING! Before installing the product, it is mandatory to read the document relating to GENERAL SAFETY
WARNINGS supplied with the product. Document 6-1620001.
The supplementary sheet can also be downloaded from www.allmatic.com.
2 - SELECTION OF THE MOTOR
WARNING! Before executing the learning of the strokes, the memorization of the transmitters and before performing
any other setting, it is necessary to select the motorization in use, this allows to optimize the operation of BIOS2 24.
ACCESS TO THE ADVANCED MENU VOICE
perform a reset by completing the countdown on the display. Refer to the table on page 18.
The procedure is as follows, in the example the KINEO 400 motor is selected (4):
WARNING! The procedure performs a restoration of the factory values causing the loss of any customizations. It does not
affect the amplitude of the programmed strokes and the memorized transmitters.
0 OTHER MOTORS (EXECUTE NECESSARY PERSONALIZATIONS)
1
XTILUS
2 INT VS
3 MINIART
4
KINEO 400
5 HYPER

>4''

>2''
2/24
de f
, select the value corresponding to the motor to be controlled and
. .


rilasciare per un istante
release for a while
relâchez pendant un moment
suelte por un rato
bir an için serbest bırakmak
kort vrijgeven
ITA ENG FRA ESP

>2''

>8''
TUR NLD
6-1622420


rev.5 14/09/2021