Allmatic BIOS2 24V Manual Del Usuario página 32

Cuadro de mando para cancelas a hoja 24v
Ocultar thumbs Ver también para BIOS2 24V:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
5.3 - MALFUNCTION SIGNALLINGS
DISPLAY
eme
J5
eex
efO
eeD
eph
eth
fuL
err
EXPANSION
CARD
eEL
J1
NOTE - The visualization of an error on the display, with the exception of the EEL error, persists until the "DOWN" button is pressed or until another
command is given.
WARNING - the restore from an EEx error must be carried out through one of the 3 buttons of the control unit (UP, MENU or DOWN).
5.4 - SIGNALLING LED
RELAY 1
RELAY 2
6
7
8
9 10 11 12 13 14 15 16 17 18 19 20 21
OPEN GATE
ELECTRICAL
LED
C
FLASH
LIGHT
LOCK
EDGE
PH2
PH1
STOP
OPEN
CLOSE
PED
SS
RADIO
POWER ON
8/24
POWER
ON
UP
MENU
DESCRIPTION
Memory error: the external memory not installed or not recognised.
SS
Memory error during the writing: the value x is a number from 1 to 6. In the event of the error, contact the technical assistance.
Impact sensor intervention.
Safety edge intervention.
Malfunctioning of photocells.
Thermical intervention to preserve the control unit.
Full external memory.
Memory error during functions viewing memory location or cancellation of a single transmitter.
Electrical lock error: the restore after the evaluation of the error must be done manually. Press and hold the "DOWN" button,
the display will show REL and then RES. Release the button.
EDGE
+24VDC
COLOUR
DESCRIPTION
GND
EDGE
+24VDC
TX PHOTO
RED
Safety signalling, Led normally ON.
RED
Safety signalling, Led normally ON.
RED
Safety signalling, Led normally ON.
RED
Safety signalling, Led normally ON.
GREEN
Led normally OFF. It is turned on when the button is pressed.
GREEN
Led normally OFF. It is turned on when the button is pressed.
GREEN
Led normally OFF. It is turned on when the button is pressed.
GREEN
Led normally OFF. It is turned on when the button is pressed.
RED
Led ON with a radio transmission or interferences.
GREEN
Led normally ON. It shows the presence of the power supply.
ITA
ENG
DOWN
J4
J3
ON
DIP-SWITCH
PH2
PH1
STOP
OPEN CLOSE PED SS COM
22 23 24
PH2
PH1
STOP
OPEN CLOSE PED SS COM
FRA
ESP
TUR
NLD
26 27
25
6-1622420
FIG. 3
rev.5
14/09/2021

Publicidad

Tabla de contenido
loading

Tabla de contenido