Steelcase FrameOne Boundary Screen Instrucciones De Montaje página 5

7.
Use the spacers to create a
½" gap between the legs and the
Boundary Screen.
NOTE: The edge of the L bracket
should line up with the leg edge
8.
Mark the locations for the pilot
holes in the leg. Then remove the
Boundary Screen from the FrameOne
assembly.
9a.
Use a center punch to stamp
each hole location.
9b.
Drill holes in the FrameOne
leg using 5/32" drill bit.
9b
BOUNDARY SCREEN
SPACER
9a
7
LEG
8
Page 5 of 63
76550 Rev B