Mopar 82213232 Manual De Instrucciones página 13

47. Lower the overhead console far enough to access the
wire harness connectors.
48. If equipped, disconnect the courtesy lamps (2), Light
Emitting Diode (LED) lamp (3), infrared temperature
sensor (4) and power sliding door/liftgate switch (1)
electrical connectors.
49. Remove the front overhead console assembly from
the vehicle.
50. Using a small pry tool or equivalent, remove the fas­
tener covers (3) from the A­pillar trim panel (1).
51. Remove the fasteners (2) securing the A­pillar trim
panel.
52. Using a trim stick or equivalent, disengage the A­pillar
trim panel, position the trim panel away and disengage
the tether. Remove the A­pillar trim panel.
53. Repeat the A­pillar trim panel removal steps on the
opposite side.
54. Disengage the visor (1) from the visor support.
55. Remove the fasteners (2) securing the visor to the ve­
hicle.
Dec 30, 2011
13
K6861508