Publicidad
Idiomas disponibles
Idiomas disponibles
3. In the "Vehicle Option" screen under the "Global Claims System" category in the "Service" tab, enter the vehicle
VIN, four digit pin number obtained from the dealership parts department and add sales code(s) noted below as a
"Dealer Installed Option".
RD9 (2nd Row Single Screen Kit), RF2 (Dual Screen Kit), RF1 (3rd Row Single Screen Kit without Swivel Screen),
RD1 (3rd Row Single Screen Kit with Swivel Screen)
4. Confirm that the new sales code has been successfully added to the VIN.
5. With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Select "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
• Note OnScreen instructions and select the "Close" button
CLEAR ANY DTC'S
NOTE: The wiTECH diagnostic application is the preferred method for clearing all DTC's.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
Dec 30, 2011
27
K6861508
Publicidad
