89. Using fishtape or equivalent, route the DVD power
harnesses (1, 2) through the opening in the front
overhead console cavity and route rearward.
90. Continue routing the appropriate harnesses (2, 3)
rearward to the rear overhead console area where
the vehicle harness (1) is present.
NOTE: If vehicle is equipped with rear park view cam
era system, refer to the section titled "IF VEHICLE IS
EQUIPPED WITH PARK VIEW CAMERA SYSTEM" in
this document.
91. Accessing through the center stack area of the instru
ment panel, connect the DVD power harness to the
existing vehicle harness (1).
92. Dual screen kit installation, connect the secondary
DVD power harness (2) to the DVD power harness.
93. There are two additional takeoff harnesses, one for
the radio (4) and one for the DVD player (3). If neces
sary, label these takeoff harnesses for later use.
Dec 30, 2011
19
K6861508