Remote Control - STEINEL PROFESSIONAL IR Quattro COM 1 Manual De Instrucciones

Parallel-connected configurations
When using several detectors,
they must be connected to the
same phase!
k
1 4. Master/master
1
A parallel-connected configuration
also permits the use of several
masters. In this case, each master
operates the lighting group in ac-
cordance with the level of bright-
k
Master/slave
1 4.
2
The master/slave configuration
permits detection of movement
in large-type rooms or spaces (load
connected = master, no load =
k
Two detectors linked with
1 4.
3
an external stairwell lighting
timer
k
Detector as stairwell
1 4.
4
lighting timer
k
DIM detector
1 4.
5

Remote control

Using the remote control, func-
tions can be conveniently activat-
ed from the floor.
It is possible to operate as many
as 10 sensors.
ness it measures. Delay times and
brightness thresholds are selected
at each master as required. The
switched load is spread among the
individual masters. Presence is still
slave). The level of brightness pre-
vailing in the room is only evaluat-
ed at the master. The slaves report
movements detected to the mas-
Old building /
building modernisation
Note: The pulse mode cannot be
overridden by the remote control.
Switch pulse mode 'OFF' manually.
- 27 -
detected collectively by all detec-
tors. The presence output can be
picked off from any master.
ter. Lighting or HVAC is switched
'ON' and 'OFF' by the master only.
External light source activated by
button. No twilight mode, day
mode only.
Presence Control remote control
unit: EAN no.: 4007841 000387