Removing The Unit - Kenwood KMM-BT525HD Manual De Instrucciones

Ocultar thumbs Ver también para KMM-BT525HD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
40
ENGLISH
Do the required wiring.
(Page 41)
Dashboard of your car
Bend the appropriate tabs to hold
the sleeve firmly in place.
Installing the unit (without mounting sleeve)
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and
secure the unit with screws (supplied/commercially available).
Use only the specified screws. Using wrong screws might damage the unit.

Removing the unit

1 Detach the faceplate.
2 Remove the trim plate.
3 Insert the extraction keys deeply into the slots on each side, then follow the arrows
as shown on the illustration.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kmm-bt325Kmr-m325btKmm-x503Kmm-bt250uKmm-bt325uKmm-bt225u

Tabla de contenido