Technical Data - OHAUS MC2000 Manual De Instrucciones

3.2 How to Perform a Test
Press the "Start" button and the instrument starts self-check.
1.
Press the "Up" and "Down" buttons to choose the category code of the respective sample to be measured (refer to
2.
section 8, category code list, in the instruction manual for details)
3. Fill the sample grain into the empty container.
4. Remove the funnel from container.
5. Remove excess grain with cover.
6. Place the container over the moisture analyzer and press the release button.
7.
Without pressing any key, the analyzer will automatically start the measurement and the moisture value will be displayed
after about 5 seconds.
4. MAINTENANCE
4.1 Cleaning
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.
4.2 Troubleshooting
For technical issues contact an Authorized Ohaus Service Agent. Please visit our website www.ohaus.com to locate the
Ohaus office nearest you.

5. TECHNICAL DATA

Typical specifications:
Model
Moisture range (%)
Readability
Temperature Range
Power
6. COMPLIANCE
Compliance to the following standards is indicated by the corresponding mark on the product.
Mark Standard
This product complies with the EU Directives 2014/30/EU (EMC), 2014/35/EU (LVD) and 2014/31/EU
(NAWI). The EU Declaration of Conformity is available online at www.ohaus.com/ce.
This product complies with the EU Directive 2002/96/EC (WEEE). Please dispose of this product in
accordance with local regulations at the collecting point specified for electrical and electronic equipment.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
MC2000
3% - 45%
0.1%
0℃-50℃
4 AA Battery
EN-3