Festo ADN-KP Serie Manual De Instrucciones página 25

KP/KPE/ADN−...−KP/DNC−...−KP/DS NU−...−KP
Avoid exceeding the static holding force (è Technical specifications).
S
Apart from that, the clamping rod can break through.
1. Slowly pressurize the complete system with at least 3 bar.
2. Exhaust the cylinder.
3. Screw in completely the adjusting screws on the cylinder for the end position
cushioning 5.
4. Start a test run as follows:
KP/KPE
Pressurize compressed air connection 2 on the clamping cartridge with 3 to max.
10 bar.
Move the clamping rod in the
longitudinal direction.
Check the clamping of the clamping rod by exhausting compressed air connection
2.
Fig. 17
5. Conclude the test run.
Festo KP/KPE/ADN−...−KP/DNC−...−KP/DSNU−...−KP 0703d
English
ADN−...−KP/DNC−...−KP/DSNU−...−KP
Pressurize both connections of the cylinder
slowly, in order to prevent danger due to the pis
ton rod moving sudddenly.
Adjust the pneumatic end position cushioning by
means of the adjusting screws (not on cylinders
with elastomer cushioning).
25