Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
INSTALLATION OF KEG COOLER
•
This appliance is designed to be free standing only and should not be recessed or built-in.
•
Place your keg cooler on a fl oor that is strong enough to support the unit when it is fully loaded.
•
Allow 8-12 cm (3-5 inches) of space between the back and sides of the keg cooler and any
adjacent wall to allow proper air circulation to cool the compressor.
•
Locate the keg cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the keg cooler not to perform
properly.
•
This unit is not designed for outside installation (i.e. garages, porches, patios etc.).
•
Avoid locating the keg cooler in excessive humidity.
•
Plug the keg cooler into a dedicated, properly installed-grounded wall outlet. Do not under any
circumstance cut or remove the third ground prong from the power cord. Any questions concerning
power and or grounding should be directed toward a certifi ed electrician or an authorized service
centre.
•
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing any contents in the keg cooler compartment.
WARNING
CO
cylinders contain high-pressure compressed gas which can be
2
hazardous if not handled properly. Make sure you read and understand all
BEER KEG INSTALLATION INSTRUCTIONS
Keg Installation Sketch
CO
GAS CAN BE DANGEROUS
2
safety procedures for CO
Pressure
Regulator
CO
Tank
2
cylinders before installation.
2
Coloured Pressure Hose
6
Faucet Assembly
Tower
Clear Hose with Wing Nut
American Sankey
Tap (Coupler)
Keg
Publicidad
Tabla de contenido
