Firmware Update; Description; Use; Before First Use - Qilive Q.5147 Manual Del Usuario

2.2

Firmware update

EN
The firmware of the appliance is automatically updated over the Wi-Fi network and
mobile phone. The robot vacuum cleaner must be connected to the charging station.
Ensure that the robot vacuum cleaner is charging and the Wi-Fi signal is good.

3. DESCRIPTION

TOP VIEW
1. ON/OFF light indicator
2. Wi-Fi light indicator
3. Recharging light indicator
4. ON/OFF power button
5. Surface cover
6. Bumper with anti-collision sensor
7. Dust bin release button
8. Dust bin
REMOTE CONTROL
9. Display
10. Auto cleaning mode / Suction
power setting
11. Direction control buttons
12. Schedule cleaning setting
13. Automatic recharging button
14. 3 cleaning modes:
(optional), single room, edge
cleaning modes
15. START / PAUSE button
16. Clock setting button
BOTTOM VIEW
17. Front anti-drop sensor

4. USE

4.1

BEFORE FIRST USE

1. Before using the robot vacuum cleaner and the accessories supplied, check for any
visible signs of damage. Do not use a damaged appliance or damaged accessories.
2. Remove and safely discard any packaging material or promotional labels attached
to the set.
3. Before using the robot vacuum cleaner, remove the protective strips from the sides
of the unit.
4. Install the side rotating brushes:
• Place the robot vacuum cleaner upside down on a smooth
and clean surface.
• Check the "L" and "R" marks on the edge-cleaning side
rotating brush and also the "L" and "R" marks on the main
unit. Install the side rotating brushes according to the "L" and
"R" markings by pressing them carefully onto the pins until
they "click" into place.
5. Install the remote
REPLACING THE BATTERIES IN THE REMOTE CONTROL paragraph for
information on the method of replacing or removing batteries.
6. Before connecting the appliance
voltage matches the power voltage marked on the charging station.
7. Ensure that the dust bin is assembled and locked firmly into place.
mopping
control batteries. Refer to the 5.5
to the power supply, ensure the power supply
12
18. Charging contact pins
19. Left side rotating brush
20. Left anti-drop sensor
21. Left driving wheel
22. Rolling brush cover frame
23. Front caster wheel
24. Right side rotating brush
25. Battery compartment cover
26. Right anti-drop sensor
27. Right driving wheel
28. Rolling brush
29. Dust bin
DUST BIN
30. HEPA dust filter
31. Primary filter
32. Dust bin metal sheet
33. Filters compartment cover
34. Conductive sheet
35. Dust bin side cover
CHARGING STATION
36. Charging contact pins
37. LED signal indicator
38. Power supply port
L
R