Qilive Q.5147 Manual Del Usuario página 23

5. When cleaning is complete, reinstall
the left side of the rolling brush first and
then fix the right side.
Note: As the rolling brush vacuums the dust and debris on the floor, long strings or hair
can become wrapped and tangled around the brush easily. Check and clean the rolling
brush regularly.
5.2.4 CLEANING THE SIDE ROTATING BRUSHES
1. To remove the side rotating brushes, hold the side rotating brushes holders and pull
them upwards.
2. Remove debris and any foreign substances such
as long hairs or strings wrapped around the side
rotating brushes using a cleaning brush's knife.
3. Wipe the side rotating brushes with a clean, dry
cloth.
4. When reassembling the brushes, check the "L"
and "R" marks on the edge-cleaning side rotating
brush and also the "L" and "R" marks on the main
unit. Then reassemble the side rotating brush.
Install the side rotating brushes according to the
"L" and "R" markings.
5. Press the side rotating brushes carefully onto their
pins until they "click" into place.
Notes:
• As the side rotating brushes easily attract hair, strings, threads and other foreign
substances, ensure to clean it frequently. Excessive foreign substances on the side
rotating brushes can damage them.
• If the side rotating brushes are bent, broken or worn, replace them with new ones.
5.2.5 CLEANING THE ANTI-DROP SENSORS
Wipe the anti-drop sensors (left, front and right) with a
clean, dry cloth. Do not spray cleaning solution directly
onto the sensors or sensor openings.
Note: Always keep anti-drop sensors clean in order to
achieve the best possible cleaning results.
5.2.6 CLEANING THE CHARGING CONTACT PINS
Wipe the charging contact pins at the bottom of the robot vacuum cleaner and on the
charging station with a clean, dry cloth.
6. Align the frame into place and press it
tight until it "clicks" into place.
23 23
L
R
EN