Rupes SL42AEV Instrucciones Original De Uso Y Manutención página 10

SELECTING THE RPM
The rpm can be adjusted by rotating the wheel (3) located on the rear
of the tool. The choice of speed depends on the characteristics of the
abrasive paper disc and the material to be worked.
ADJUSTING THE DUST EXTRACTION FLOW
The extraction flow can be adjusted by rotating ring-nut (4).
REPLACING ABRASIVE PAPER
ABRASIVE VELCRO PAPER
- Rip off the used paper;
- press the new velcro backed paper in position, ensuring that the
holes in the paper coincide with the suction holes in the plate.
ABRASIVE PAPER
- Lift the paper clamping lever (7) by pressing the release device and
remove the used paper;
- insert the new abrasive paper following the instructions in the chap-
ter on "INSERTING THE ABRASIVE PAPER".
USABLE ABRASIVE PAPER
- Sheets of abrasive paper for orbital sanders.
- Sheets of abrasive paper with suction holes.
MAINTENANCE
All maintenance operations are carried out with the power supply di-
sconnected.
At the end of each work session, or when required, clean the motor
ventilation slot protective filter and remove any dust from the body of
the tool using a jet of compressed air, paying particular attention to
the motor ventilation slots.
No other maintenance operations must be undertaken by the user.
Maintenance and cleaning of the inner parts, like brushes, ball bea-
rings, gears etc. or others, must be carried out only by an authorized
customer-service workshop.
ELECTRIC SAFETY - LOW TENSION
The tests have been carried out in accordance with the standard:
EN 60745-1 safety of hand-held electric motor operated tools
10
EN 60745-2-4 particular requirements for sanders.
RADIO SUPPRESSION
The tools are suppressed in accordance for the prevention and elimi-
nation of radio disturbances measured in accordance with standard:
EN 55014-1 + EN 55014-2; EN 61000-3-2 + EN 61000-3-3.
NOISE
The noise level produced is 86 dB(A) / K = 3 dB(A) measured
according to standard EN 60745-1.
Warning: wear suitable hearing protections! (see warnings).
MEAN ACCELERATION VALUE
The mean quadratic acceleration value is 5.5 m/s
measured according to standard EN 60745-1.
GUARANTEE
All tools manufactured by RUPES Spa are guaranteed for 12 months
from the date of purchase against fabrication and material defects. All
tools must be used only with RUPES original accessories and spare
parts: we refuse all responsibility for damages or accidents caused by
non-observance of this rule which will also cause the termination of
the guarantee. The guarantee will no longer be valid if the instructions
contained in this booklet are not followed, if the tool is used for pur-
poses other than that for which it is intended, if it is dismantled, inter-
fered with in any way or damaged due to neglect. The guarantee will
be made valid by filling-in the form on the inside back cover of
this instruction booklet. If the tool is found to be defective or mal-
functions, it should be returned carriage free in one piece in its origi-
nal packing together with the guarantee certificate to the manufacturer
or to one of the Assistance Centres listed in the appendix to this boo-
klet. The guarantee does not automatically imply replacement of the
tool. RUPES Spa reserves the right to make any technical or design
modification to its products without prior notice. The manufacturer is
not liable for any print errors. This document voids and replaces pre-
vious ones.
/ K = 1.5 m/s
2 2