Technical Data; General Warnings; Correct Usage - Rupes SL42AEV Instrucciones Original De Uso Y Manutención

TECHNICAL DATA

PROTECTION CLASS
ABSORBET POWER
ELECTRONIC OVERLOAD
ELECTRONIC SPEED CONTROL
ROTATION R.P .M.
Ø ORBITAL mm
VELCROED DRILLED RUBBER PLAT
PLATE DIMENSION mm
VACUUM SISTEM
WEIGHT Kg
The values shown are based on a nominal voltage of 230V/50Hz. In the case of voltages and frequencies of different power values may vary.
Refer to the label technical specifications to the nominal values of the tool.
The tool must be connected to a suitable dust extraction system (not supplied).

GENERAL WARNINGS

The safety and accident prevention instructions are reported in the
"SAFETY INSTRUCTION" booklet which forms an integral part of
these documents; the operating instructions indicate the additio-
nal information required specifically for use of the tool.

CORRECT USAGE

This electrical tool is designed to be used as a sander. Read all
the warnings, instructions, indications provided on drawings and
specifications supplied with this electrical tool. Failure to comply
with all the instructions provided below may cause electrical shocks,
fires and/or serious injuries.
This tool is not intended to be used for metal brushing, polishing
and cutting operations. The use of this tool for unintended applica-
tions may cause hazards and injuries to people.
The tool must be used with accessories that have been specifi-
cally designed or recommended by the manufacturer. The fixing of
the accessory to the tool does not guarantee a safe operation.
The rated speed of the accessory must be at least equivalent to
the maximum speed specified on the electrical tool. Using the ac-
cessories at speeds above the rated one may cause them to break or
be projected into the air.
The external diameter and thickness of the accessory must match
TYPE
the specifications of the electrical tool. Accessories with incorrect di-
mensions cannot be adequately protected or controlled.
The configuration of grinding wheels, flanges, support pads or
any other accessory must match the electrical tool. The use of ac-
cessories that cannot be perfectly fitted on the electrical tool may re-
sult in imbalance, excessive vibrations and in the impossibility of
controlling the tool.
Do not use damaged accessories. Before use, inspect all the ac-
cessories. Inspect the abrasive grinding wheels and verify that
there are no splits or cracks. Inspect the supporting pads and ve-
rify there are no cracks, tears or excessive wear. Inspect the metal
brushes and verify that there are no loose or broken wires. If the
electrical tool or accessory has fallen, verify that it is not dama-
ged or install a new accessory. After inspecting or installing an ac-
cessory, test the operation of the tool at maximum speed and
without load for one minute, keeping at a safety distance. If the ac-
cessories are damaged, they will break during this test.
ENGLISH
8
SL42AEV
II
550 W
•
•
3.000÷7.000
4,8
•
400 x 70
•
2,6