Attaching Or Removing The Comb Attachments; Using The Trimming Height Comb Attachment - Panasonic ER‑GS60 Instrucciones De Operación

2
2
Put the power plug into a household outlet.
• The charge indicator lamp glows red.
• Charging time differs depending on the rated voltage.
RE7‑69
Charging time
RE7‑74 for
the United
Kingdom
• When charging the clipper for the first time or when it has
not been in use for more than 6 months, the charge
indicator lamp may not glow for a few minutes, or the
operating time may shorten. Please charge it for more than
20 hours in such cases.
3
3
Disconnect the power plug after charging is
completed.
• To keep charging the battery will not affect battery performance.
• Recommended ambient temperature for charging is
0 – 35 °C. The battery may not charge properly or not at all
under extreme low or high temperatures.
• The charge indicator lamp glows and stays on until the
power plug is disconnected from a household outlet.
• A full charge supplies enough power for approximately
40 minutes of use.
Note
You cannot operate the clipper while charging.
10
Approx. 10 hours
220 V
Approx. 8 hours
230 V
Approx. 12 hours
220 V
Approx. 8 hours
240 V
Attaching or removing the comb attachments
• Make sure that the clipper is turned off.
► 1 mm comb attachment
Attach/remove the comb attachment to/from the main body.
• It will make a clicking sound when attached correctly.
► Trimming height comb attachment
Attach to/remove from the main body while pressing on the 3 mm
adjustment buttons.
• It will make a clicking sound when attached correctly.
Using the trimming height comb attachment
• Make sure that the clipper is turned off.
1. Mount the trimming height comb
attachment to the main body.
2. Slide up and down while pressing on
the 3 mm adjustment buttons.