Removing The Built-In Rechargeable Battery; Specifications - Panasonic ER-GP30 Instrucciones De Operación

Removing the built-in rechargeable battery

Remove the built-in rechargeable battery before disposing the
clipper.
Please make sure that the battery is disposed of at an officially
designated location if there is one.
This figure must only be used when disposing the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it may cause malfunction.
• Remove the clipper from the AC adaptor.
• Slide the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps 1 to 6 and lift the battery, and then remove it.
• Take care not to short circuit the positive and negative terminals
of the removed battery, and insulate the terminals by applying
tape to them.



For environmental protection and recycling of materials
This clipper contains a Nickel‑Metal Hydride battery.
Please make sure that the battery is disposed of at an officially
assigned location, if there is one in your country.
ER-GP30_EU.indb 13




Specifications

See the name plate on the AC adaptor.
Power source
(Automatic voltage conversion)
Motor voltage
1.2 V
Charging time Approx. 8 hours
13
2016/05/06 17:51:46