How To Set The Alarms; Disabling An Alarm - Oregon Scientific WR113 Manual De Usuario

Radio meteorológica portátil con termómetro y alerta de helada
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10. Press MODE or wait 9 seconds to exit the Clock-
Setting Mode and return to the time display.

HOW TO SET THE ALARMS

The WR113 has 2 alarms (Alarm 1 and Alarm 2). They
can be used together or independently. The Alarm icons
are only displayed when Alarm 1 or Alarm 2 are active.
No icon(s) indicate that the alarm(s) have not been set.
Remember: From the Clock-Display mode, press MODE
to enter Calendar-Display and then again to set Alarm 1.
Press MODE once more to set Alarm 2.
Setting the Alarm:
1. With the clock displayed, press MODE until alarm
(1 or 2) display is entered.
NOTE The last set time of the alarm will be displayed.
If you have not set the alarm before, or if the alarm has
been disabled, the time will be displayed as [----].
2. Press and hold MODE for 2 seconds.
Remember: At any stage of the setting sequence, if no
entry is made after 9 seconds, the unit will automatically
return to the Clock-Display mode.
3. To enter the hour, press
hour has been selected.
Remember: Pressing and holding
digits in rapid sequence.
4. When the desired hour is reached, press MODE to
advance select minutes. Press
values.
5. After selecting the minutes, press MODE or wait
9 seconds to exit Alarm-Setting Mode and return to
Clock-Display mode. The alarm ON icon (
the chosen alarm, will be shown to indicate that the
alarm is set and will sound at the set time.
When an alarm goes off, it will sound for 1 minute, the
EL backlight will activate. Alarms 1 and 2 are identifi ed
by different sounds: Alarm 1 has 2 short bursts of sound
followed by a pause which then repeats. Alarm 2 has 4
short bursts of sound followed by a pause, which then
repeats. Unless disabled, the alarms will sound for a
total of 1 minute before automatically turning off.

DISABLING AN ALARM

When disabled, the respective alarm icon will not be
displayed. A disabled alarm display is indicated by
blanks [----].
14
or
until the desired
or
will advance
or
to change
) for

Publicidad

Tabla de contenido
loading

Tabla de contenido